EN
Also
especially
ensure
when
setting up the tripod leg that the
mounting for the ocular shell is on
the inside!
Remove a butterfly nut from one
of the three screws and put the
screw through the hole, so that
the connection of the tripod and
the mounting of the tripod mount
is fixated.
Now the first leg is mounted and it
should look like on the picture here.
The tripod leg and the tripod mount
are firmly connected and the mounting
for the ocular shell is pointing
inwards.
Repeat these steps for the mounting
of the tripod leg and mount the second
and third leg the same way.
All mountings for the ocular shell point
inwards.
If the 3 screw to fixate the tripod legs
aren’t attached already, then please
screws them into the tripod legs.
Raise the mount for the
ocular shell on the tripod
and place the corner of
the ocular shell as far
outside as possible. Now
insert the small screw
with the wing nut and
pull it tight carefully.
Repeat
with
the
remaining two brackets.
