13
Pulling once more will dim
the light to its lowest set-
ting, which is 25 Lumens.
One more pull on the Pull
Switch will turn off the light.
To accommodate for
different height require-
ments, the cord length for
the Pull Switch can be
changed using the spool
found in the Switch itself.
Remove, adjust and
replace as shown.
When the
AnyWhere
light
is being charged by the
Solar Panel, the Green light
indicator located inside the
light lens will start to flash.
Once the integrated battery
is fully charged, the Red
light indicator will glow
permanently whilst the unit
is connected to the Solar
Panel but not being used.
If the light unit is being used
but not recharged by the
Solar Panel, the integrated
battery will become
discharged and light will not
work after a period of time.
In this situation, ensure that
the Solar Panel is correctly
positioned (see earlier
chapters) and allow time
during daylight hours for
electricity to be collected,
produced and transferred to
the integral battery.
To prolong the light life
between charges, it is
always recommended to
turn the
AnyWhere
light off
when it is not needed and
to dim from the maximum
brightness as required.
Green
Indicator
Red
Indicator
