• If test not passed appears, click
continue installation.
(This warning may appear several times.)
• When
driver install success or driver successfully pre-installed appears, you can connect
driver successfully pre-installed
driver successfully pre-installed
the vinyl cutter to your PC.
• The Windows hardware assistant appears.
• Choose:
No, not this time, press continue.
• Choose:
install software automatically, press
install software automatically
install software automatically
continue.
• If test not passed appears, click
continue installation.
• Click
finish.
• Press (Pause).
Select the tab “Hardware”. Click on “Device Manager”. Check the port number of your
Secabo CIII under Ports(COM and LPT).
Make a note of the number (e.g. COM1).
• If the Port Number is greater than COM9. You have to change it to a Port from COM1 to
COM9.
The first cut job
• Open the
FlexiStarter cutting software.
FlexiStarter
FlexiStarter
• Select
Preferences from the
Preferences
Preferences
Edit menu.
Edit
Edit
• Select the
Tools tab and click
Tools
Tools
Cut/Plot.
• Uncheck the checkbox
Connect to local Production Manager using TCP/IP.
Click the
OK button.
OK
OK
• Create your inscription or graphic and click
cut/plot in the file menu or on the symbol
cut/plot
cut/plot
• The
Choose Production Manager Window appears.
Select
On this PC (local) Press OK.
• Wait until the Production Manager has started.
• Select your Secabo vinyl cutter model
C30III, C60III or
C30III, C60III
C30III, C60III
C120III.
• Choose as connection to the PC, the COM Port you have noted. (see USB driver installation)
• If you can’t find the COM port, which you have noted, you have to reboot your system.
• The Window Cut/Plot appears, click on
Properties.
• The Windows
Default Job Properties appears.
• Select the 3. tab
• Activate Knife offset and enter a value between 0,020cm and 0,033 cm.
The exact value differs from knife to knife.
• Click
OK and Click
OK
OK
Send in the Cut/Plot Window.
Send
Send
• The Cutting Process starts.
www.secabo.com
