INSTALLATION - SED-902 Expander Programming
10
The Sed 902 Master & Remote Expanders
To enrol a board for self learning
1/
Ensure they are all wired and configured and set up also check dip
switches
2/
On the (Master Expander) board the press the Copy & Prog buttons until
the signal leds begin to flash. The unit is now in self learning and is waiting
to link with a remote.
3/
Press and hold the Copy & Prog buttons on your remote expander until its
Signal led's begin to flash The unit is now in self learning and is waiting to
link with a Master.
Both the Master expander board and the Remote expander board should
now communicate and link with one another.
If not repeat the process.
