ENFORCER Split Series Keypad with Proximity Card Reader
26
SECO-LARM U.S.A., Inc.
A 24-hour real-time clock provides the baseline time needed to start and stop the output #1
auto-disable time (see "Programming the Output #1 Auto-Disable Time" below).
If the output #1 Auto-Disable Time is not programmed, it is not necessary to set the real-time clock.
To set the clock, use this general formula:
– Program Real-Time Clock
– Hours
– Minutes
Setting Hours and Minutes:
•
represents hours and
represents minutes in the military (24-hour) time format,
from 00:00 to 23:59.
Examples:
•
Set the real-time clock to 11:30 AM:
•
Set the real-time clock to 7:15 PM:
NOTE:
•
If the output #1 auto-disable time is programmed, losing power will cause the keypad to
beep 3 times every 5 seconds. To deactivate this alert, either reset the real-time clock
or clear the output #1 auto-disable time.
•
If the output #1 auto-disable time is not programmed, losing power will not cause the
keypad to beep.
•
To ensure accurate time, it is advised to re-program the real-time clock every three to six months
and when Daylight Savings Time begins and ends (if applicable).
Programming the Output #1 Auto-Disable Time:
The keypad can be programmed so that output #1 is disabled for a certain period of time every
day. Output #1 will be disabled at the start time, and will be re-enabled at the end time. This
ensures that users are not allowed into the protected premises, such as during lunch hour
or at night.
NOTE:
•
The real-time clock must be operating in order to set the output #1 auto-disable time (see
"Programming the Real-Time Clock" above).
•
For safety purposes, the egress button still works while output #1 is auto-disabled.
•
The time is set using the military (24-hour) time format (00:00 to 23:59).
Programming the Real-Time Clock:
