ENFORCER Split Series Keypad with Proximity Card Reader
6
SECO-LARM U.S.A., Inc.
Dimensions:
1
1
/
4
" (32mm)
4
3
/
4
"
(120mm)
Keypad
Controller
Installation:
Keypad (SK-4131-SPKQ)
1.
Find a suitable location to mount the keypad. Install it at the height at which most users will be
able to easily operate the keypad.
2.
Install one mounting screw on the wall. After the screw has been installed, hang the back box
by the top mounting hole.
3.
Install the second mounting screw through the button hole.
4.
Run the wire through the wall or conduit from the controller to the back box location, then run
the wire through the back box.
5.
Refer to the wiring diagram on pages 8~9 and connect the wires.
6.
Finish assembly by attaching the keypad to the back box with the included screws.
Controller (SK-4131-SPCQ)
1.
Find a suitable location to mount the controller. Install it where it is secure and only accessible
by authorized personnel.
2.
Using the included mounting screws, install the controller on the wall.
3.
Remove the cover using a screwdriver. Run wires through the wall or conduit to the controller.
4.
Refer to the wiring diagram on pages 8~9 and connect the wires.
5.
Finish assembly by reattaching the cover and cover screws.
Parts List:
1x Keypad
1x Keypad back box
1x Controller
2x Installation screws
5x Mounting screws
5x Mounting screw anchors
2x Diodes
1x Manual
3
7
/
16
"
(87mm)
4
5
/
8
"
(117mm)
2
7
/
8
"
(73mm)
1
1
/
2
"
(38mm)
