SBC-C23
SBC-C23 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: S.B. - Reviewed by L.B. -Copyright © 2020 SECO S.p.A.
13
2.1
Introduction
SBC-C23 is a Single Board Computer, measuring just 89.5 x 87 mm (3.52
”
x 3.43
”
) based on embedded NXP i.MX6SoloX processors, a Single Core ARM
®
Cortex
®
-
A9 processor, with frequencies up to 1GHz, which is ideal for applications requiring low power consumptions, security features and connectivity, like i.e. IoT
applications.
Graphics features of the board are managed directly by NXP i.MX6SoloX processor, which integrate a Vivante GC400T 2D/3D GPU, supporting OpenGL
®
ES2.0.
The board is completed with up to 1GB DDR3L directly soldered on board, and one eMMC Flash Drive, directly accessible like any standard Drive, with up to 8GB
of capacity. Mass storage capabilities are completed by a microSD Card slot.
The two RGMII i.MX6 native interfaces are internally carried to as many Micrel KSZ8091 Ethernet Transceiver, allowing the implementation of up to 10/100 Gigabit
Ethernet interfaces (one of them optional).
The communication / networking capabilities of the board are completed by an M.2 Key B Slot, which allows plugging WWAN USB modules, by an M.2 Key E Slot,
for the connection of modules with PCI-e interface, by an optional WiFi + BT LE embedded module (Single Band or Dual Band) and by an optional modem soldered
on-board (supporting GSM/GPRS, LTE Cat. 1 or LTE Cat. M1 / NB).
The M.2 Key B Slot and the embedded modem can rely on an on-board microSIM slot or e-SIM soldered on-board.
The i.MX6 SoloX offers up to three USB interface. The first USB OTG port is carried out to a USB micro-AB connector, while the second USB port is carried to an
USB 2.0 Hub controller, which allows the management of an USB 2-0 Type A port, of two USB 2.0 ports on M.2 Key B and M.2 Key E slots and for the communication
with the optional 2G / LTE Cat.1 / LTE Cat. M1/NB1 modem.
The standard functionalities of this board are then completed by two 10-pin expansion connectors, which carry out two PWM ports, an I2C interface, four A/D inputs,
an RS-232 port, am RS-485 port and two CAN Bus interfaces.
Please refer to following chapter for a complete list of all peripherals integrated and characteristics. Not all combinations of these features are offered simultaneously;
please visit SECO
’
s website for a description of standard configuration modules offered. Configurations different from the standard offered must be evaluated
singularly; please contact a SECO
’
s sales representative / distributor for this.
