SBC-C41-pITX
SBC-C41-pITX User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: A.R./S.B. - Reviewed by M.B. Copyright © 2021 SECO S.p.A.
53
4.3.17
Embedded Controller submenu
4.3.17.1
Monitor hardware parameters and settings submenu
This submenu contains Monitor hardware parameters and settings information:
-
Up time
-
CPU FAN speed
-
RAM Temperature
-
VCGI_RUN
-
VNN_RUN
-
MEM_VDD_SUS
-
1.24V_ALW
-
1.8V_ALW
-
1.05V_RUN
Menu Item
Options
Description
Power Fail Resume Type
Always ON
Always Off
Last State
Specify what state to go to when power is re-applied after a power failure (G3 state). If Batteryless
Operation, the chipset always powers on after a power failure: Always Off Resume Type or Laste State
when Last State was OFF will therefore require an immediate shutdown
No C-MOS battery handling
Disabled / Enabled
In systems with no C-MOS battery, the chipset always powers on after a power failure: Always OFF
Resume Type or Last State when Last State was OFF will therefore require an immediate shutdown
OUT 80 redirection port
None / 1 / 2 / 1+2
Selects which Embedded C
UART(s) will receive OUT80 Post Codes: it can be none, 1 , 2 or
1+2
Hardware Monitor
See Submenu
Monitor hardware parameters and settings
Reset Causes Handling
See Submenu
Reset Causes Handling
Super IO Configuration
See Submenu
Super IO Configuration
Internal FAN Settings
See Submenu
Internal FAN Settings
Watchdog Configuration
See Submenu
Configure the Watchdog Timer
GPIO Configurations
See Submenu
GPIO Configurations
