SBC-C43
SBC-C43 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: A.R. - Reviewed by S.R. -Copyright © 2020 SECO S.p.A.
15
2.3
Electrical specifications
SBC-C43 needs to be supplied only with an external 12V
DC
± 10% power supply, with a minimal 60W power rating (SBC-C43 power consumption
by itself is around 18W, more power is required for the possible attached devices).
This voltage can be supplied through a Right-angle connector type Molex Mini-Fit Jr, p/n 39-30-0040 or equivalent, with the pinout indicated in the
table below.
Power available
When powering SBC-C43 with a PSU with characteristics greater or equal to the one described at beginning of previous paragraph, please consider well what is the
typical scenario for using the board (i.e., which peripherals will be connected)
Since all the power must be supplied by an external PSU only, please balance well the typical final configuration, considering both the power consumption of the
board itself and the power consumption of external devices.
This way it is possible to calculate preliminarily if a 60W PSU can be sufficient for system needing or if most powerful PSUs are required.
Power In Connector CN38
Pin Signal
Pin Signal
1
GND
3
VIN_SYS
2
GND
4
VIN_SYS
