SBC-C43
SBC-C43 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: A.R. - Reviewed by S.R. -Copyright © 2020 SECO S.p.A.
17
Batteries supplied with SBC-C43 are compliant to requirements of European Directive 2006/66/EC regarding batteries and accumulators. When putting out of order
SBC-C43, remove the batteries from the board in order to collect and dispose them according to the requirement of the same European Directive above mentioned.
Even when replacing the batteries, the disposal has to be made according to these requirements.
Power rails naming convention
In all the tables contained in this manual, Power rails are named with the following meaning:
_RUN: Switched voltages, i.e. power rails that are active only when the board is in ACPI
’
s S0 (Working) state. Examples: +3.3V_RUN, +5V_RUN.
_ALW: Always-on voltages, i.e. power rails that are active both in ACPI
’
s S0 (Working), S3 (Standby) and S5 (Soft Off) state. Examples: +5V_ALW, +3.3V_ALW.
_U: unswitched ACPI S3 voltages, i.e. power rails that are active both in ACPI
’
s S0 (Working) and S3 (Standby) state. Examples: +1.5V_U
Other suffixes are used for application specific power rails, which are derived from same voltage value of voltage switched rails, if it is not differently stated (for
example, +5V
HDMI
is derived from +5V_RUN, and so on).
