SBC-C43
SBC-C43 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: A.R. - Reviewed by S.R. -Copyright © 2020 SECO S.p.A.
16
Power consumption
Using the following setup, the current consumption has been measured on +12VDC V
IN
power line.
•
CPU: i.MX8 QuadMax
•
8GB LPDDR4
•
16GB eMMC onboard
•
HDMI FHD display connected (no additional peripherals)
RTC Battery
The SBC-C43 board can be equipped with an optional low-power Real Time Clock embedded on the module (which is a NXP PCF2123).
If the board is not equipped with the optional rechargeable battery, then it will be available a soldered horizontal 3V coin cell lithium battery to supply the RTC.
The battery used is a not-rechargeable CR1225 Lithium coin-cell battery, with a nominal capacity of 48mAh, , to supply such an RTC. The battery must be plugged
on the onboard battery holder CN43.
In case of exhaustion, the battery should only be replaced with devices of the same type. Always check the orientation before inserting and make sure that they are
aligned correctly and are not damaged or leaking.
Never allow the batteries to become short-circuited during handling.
Status
Average Value
Peak Value
Idle
6.63W
0.55A
6.71W
0.56A
OS Boot
--
--
10.7W
0.891A
Video reproduction 1080p 60fps
8.02W
0.668A
8.51W
0.708A
Stress Test 1
8.36W
0.696A
9.29W
0.774A
Stress Test 2
11.89W
0.99A
13.43W
1.119A
Stress Test 3
13.06W
1.087A
15.03W
1.251A
Stress Test 4
17.37W
1.446A
18.1W
1.507A
CAUTION: handling batteries incorrectly or replacing with not-approved devices may present a risk of fire or explosion.
