TOOLBOX CONTENTS
PACKAGE CONTENTS
YOU WILL ALSO NEED
1x
Chair Backrest
1x
Chair Seatbase
1x
Wheelbase
2x
Armrests
1x
Tilt Mechanism
1x
Toolbox
5x
Casters (Wheels)
1x
Hydraulics Piston
2x
Side Covers
2x
Lever Handles (For multi-tilt only)
4x
M8 Screws
8x
Spring Washers
2x
Phillips (Cross) Screws
1x
Allen Key
1x
Phillips (Cross) Head Screwdriver
1
5
7
10
11
12
8
6
9
a
9
b
4
2
3
Remove all parts from the box, while taking
care to avoid the backrest recline lever and
backrest bracket. Check if there are any
missing parts.
CAUTION: Do not adjust the recline lever until the
backrest has been securely installed
(Step 6).
Doing
so may cause the backrest bracket to spring forward.
Align the backrest with the bracket on the
right side of the chair. Attach the backrest
using the M8 screws.
Attach the side covers with the Phillips
screws using a Phillips (cross) head
screwdriver. Take care not to over-tighten.
Line up the grooves inside the lever
handles with the notches and insert
firmly.
Lift up the assembled wheelbase and
insert the hydraulics piston into the
socket of the tilt mechanism.
Carefully tilt the chair upwards while
holding the wheelbase and position
it upright.
Congratulations! You’ve
assembled your Secretlab chair.
Lift the chair and gently set it facing
downwards.
If you are assembling an
OMEGA or TITAN, proceed to Step 9a.
For Throne V2, skip to Step 9b.
Push the bracket on the left side inwards
to meet the backrest, and secure using the
M8 screws. Tighten all 4 screws fully using
the Allen key.
Attach the multi-tilt mechanism to the
bottom of the seatbase using the 4 M8
screws. Ensure the mechanism is in the
correct direction. Proceed to Step 10.
Attach the full-tilt mechanism to the
bottom of the seatbase using the 4 M8
screws. Ensure the mechanism is in
the correct direction. Skip to step 11.
Remove the 4 M8 screws that are pre-
installed in the backrest.
Lay out the foam sheets found in the
packaging on a flat surface. Place the
wheelbase upside down on top of the
foam and insert the 5 casters.
Turn the wheelbase the right side up and
insert the hydraulics piston. Slide the
hydraulics sleeve over the piston.
FOR OMEGA / TITAN
FOR THRONE V2
FOR OMEGA / TITAN
