1. Press the EIN/ON key.
2. Key-in the 9-figure mastercode. If you have selected an opening delay of 0 minutes, proceed with step 4.
3. Press the ENTER key once and wait for the opening delay to lapse. Following that, press the ENTER key once more
whilst the short, high-piched signal tones are sounding. Now enter your mastercode once more.
4. Hold the ENTER key pressed down (6 seconds), until you hear a long, high-pitched signal tone.
5. Enter "0" if you want to change the mastercode (9 figures) or any number between 1 and 9, if you want to change
a standard code.
6. Press the ENTER key.
7. Now key in your new code (6 to 8 figures for a new standard code, or 9 figures for a new mastercode).
8. Press ENTER key.
9. Key in the new code once more.
10. Press ENTER key. If you have performed the coding process correctly, you will hear 2 long, high-pitched signal
tones.
The sounding of two long, low-pitched tones indicates that you made a mistake entering the numerical code. Please
start over at 1.
TEST - TO BE CARRIED OUT WITHOUT FAIL!
It should not be possible to turn the lock handle half a turn with the door open and
blocked. Press the EIN/ON key, key-in the new numerical code and press the ENTER
key. It should now be possible to open the lock by turning the lock handle half a turn.
DELETING A STANDARD CODE
Proceed exactly as indicated under "programming a numerical code by means of the mastercode" until step 6. Instead of
keying in the new numerical standard code, enter the figure "0" ten (10) times in a row, complete by pressing the ENTER
key. The previously selected combination is now cleared and a new combination can only be coded by means of the
mastercode.
CHANGING A NUMERICAL STANDARD CODE
WHEN CHANGING A NUMERICAL CODE MAKE SURE THE DOOR IS OPEN AND BLOCKED: DO NOT
ENTER PERSONAL DATA (such as your birthday).
If the set numerical code is lost, it is only possible to open the safe or strongroom by using the mastercode or another valid
standard code. Therefore:
DO NOT FORGET THE NEW NUMERICAL CODE; KEEP IT IN A SAFE PLACE!!
1. Press the EIN/ON key.
2. Key-in the old numerical code. If you have selected an opening delay of 0 minutes, proceed with step 4.
3. Press the ENTER key once and wait for the opening delay to lapse. Following that, press the ENTER key once more
whilst the short, high-piched signal tones are sounding. Now enter your old numerical code once more.
4. Hold the ENTER key pressed down (6 seconds), until you hear a long, high-pitched signal tone.
5. Enter 1 (or 2, 3 ... 9) if you hold the first (or second, third, ... ninth) combination.
6. Press ENTER key.
7. Now key-in your new combination of 6 to 8 figures (e.g. 2 4 7 3 5 8).
8. Press ENTER key.
-- page 3 --
