P0031-LU-01.00 33
4.
Touch-Tone Remote Control
Introduction
The
SEC8
onboard communicator can be used to remotely control your alarm via any touch-
tone telephone. Once the call is answered by the control panel you will be assisted by voice
prompts to enter your normal access code, if the code is accepted a voice prompted menu is
played to you. From the main menu you can arm and disarm the system and turn outputs on
and off.
Remote Control Menu
Function Touch-Tone
Command
Away Arm
*1#
Stay Arm (1)
*2#
Disarm
*0#
Playback Speech Messages
*7?#
(? = 1 to 4)
Record Speech Messages
*8?#
(? = 1 to 4)
Turn Remote Control Outputs On or Off
*9?#
(? = 1 to 5)
Play main menu
*#
End Call
*99#
Remote Access
To gain remote access to your alarm system, please proceed as follows:
1.
From any touch-tone telephone, first dial the number of your premises. If your premises
have more than one line, be sure to call the number of the line on which your SEC8
control panel has been installed. After a single ring, hang up, wait 10 seconds, and call
again. On the second call, the system will answer after one or two rings and announce:
“Enter passcode.”
2.
Enter your normal access code within 5 seconds or the system will attempt to answer
the call in modem mode (you will hear a high pitched tone). The system will then
prompt the current status:
“System Disarmed”
or
“System Armed”
or
“System Stay Armed”
3.
The main menu is prompted:
“Press 1 to away arm, press 2 to stay arm, press * to hear again.”
4.
Enter the function command (see remote control menu).
5.
To end the remote access session, enter
*99#
on your touch-tone phone.
