2
no key press in 10 seconds. Standby status is indicated by two short beeps.
5. Automatic Re-lock
The safe lock system automatically relocks after 6 seconds of being opened by a
valid code.
6. Low Battery Alert
a) Repeated beeping (8 beeps) during an unlock operation indicates that the battery
is low and needs immediate replacement.
b) Manufacturer recommends the use of 9-Volt standard alkaline batteries (Duracell
or Energizer brands are recommend) replaced annually.
USER PROGRAMMING INSTRUCTIONS
1. ALWAYS PERFORM OPERATIONS WITH THE SAFE LOCK SYSTEM UNLOCK
AND THE SAFE DOOR OPEN.
2. Before closing the door, make sure all of the program changes are correct.
3. The system will not allow the User Code to be set to six zeros or six nines.
1. To Change Code
a) Enter “0” six times. One beep will sound, indicating that the entry is valid and the
system is awaiting the code change.
b) Next, enter the existing six (6) digit code one time. One beep will sound, which
indicates that the entry is valid.
c) Enter a new six (6) digit code one time. Two beeps will sound, indicating the entry
is valid.
d) Re-enter the new six (6) digit code. One beep will sound, indicating the codes
entered in steps c and d are the same and the code changing process is
successful.
e) If Three beeps sound, the code change process has been unsuccessful. The
existing code is still valid. Repeat steps a to d.
Note:
a) User Code can’t be 000000 or 999999.
b) Verify the new code at least 3 times before closing the door to make sure the
code has been programmed correctly.
c) The system will revert to standby status if there is no key press within 10
seconds. Standby status is indicated by two short beeps.
2. Add User (ID 02 to ID 09)
