3
a) Enter the manager code and hold down last digit until one beep sounds,
followed by two beeps.
b) Push “1”. One beep sounds.
c) Enter the ID of the user to be added. For example, enter 2 to add user ID 2. One
beep sounds.
d) Enter a desired six (6) digit code once. One beep sounds.
e) Re-enter the six (6) digit code. One beep sounds, indicating the codes entered
in steps c and d are the same and the user code has been added successfully.
f) If two beeps sound, the process failed. Repeat steps a to d.
Note:
a) User Code can’t be 000000 or 999999.
b) Verify the new code at least 3 times before closing the door to make sure the
code has been programmed correctly.
c) The system will revert to standby status if there is no key press within 10
seconds. Standby status is indicated by two short beeps.
3. Delete User (ID 02 to ID 09)
a) Enter the manager code and hold down last digit until one beep sounds, followed
by two beeps.
b) Push “3”. One beep sounds.
c) Enter the ID of the user to be deleted. For example, enter 2 to delete user ID 2.
One beep sounds.
d) Enter the deleted user code to make sure the code is deleted.
4. Disable User (ID 02 to ID 09)
a) Enter the manager code and hold down last digit until one beep sounds, followed
by two beeps.
b) Push “2”. One beep sounds.
c) Enter the ID of the user to be disabled. For example, enter 2 to disable user ID 2.
One beep sounds.
d) Enter the disabled user code to make sure the code is disabled.
5. Enable User (ID 02 to ID 09)
a) Enter the manager code and hold down last digit until one beep sounds, followed
by two beeps.
b) Push “1”. One beep sounds.
c) Enter the ID of the disabled user to be enabled. For example, enter 2 to enable
user ID 2. One beep sounds.
