SafeLogic Xtreme Installation and Operation Instructions
Doc. No. XU-EC1501A-X151123
SecuRam Systems Inc.
Page 10
Step 1: Install the 9V ALKALINE battery in the back of the EntryPad. Embossed in the bottom of
battery compartment you will see the battery orientation markings: “+” and “-“. Install
the battery with the correct orientation as indicated by the “+” and “-“.
Note: If at any time, after inputting a code you hear 8 rapid continuous beeps, it means that the
battery needs replacing. Please be sure to replace with either Energizer or Duracell Alkaline 9V
batteries.
Step 2: IMPORTANT: Pull up on the SpinDial release to disengage the electronics. Rotate
the Dial 180 degrees to “50”.
Step 3: Now install the EntryPad onto the DialRing. The EntryPad should be properly seated on
to the DialRing, with the keypad face upside down.