Up to a maximum of five end points supported. The
number of end points on the product is detected based
on the number of external sensors connected to the
product at the time of Inclusion.
If external sensor not connected this command class is
not supported.
Note: external digital sensors must have correct
hardware address otherwise it will not work.
For example: If one external sensor is connected it
should have HW address 1. If two external sensors are
connected it should have HW address 1 and 2
Note: Refer to the Pipe/Tank temperature sensor (SES
00x) manual for device address setting.
19
Summary of Contents for SES 302
Page 6: ...a Push spring clips to release b Swing wallplate out and down Wallplate 6...
Page 31: ...NOTES 31...
Page 32: ...32...
Page 33: ...33...
