and the controller. The sensor should be
mounted on an internal wall, approximately
1.5 metres (5 feet) above floor level and
away from draughts, direct heat sources and
sunlight.
Make sure that there is sufficient space
around the unit to allow easy access to the
two retaining spring clips on the base of the
wall plate.
It may be necessary to move the sensor
around to ensure good communication.
Do not attempt to mount it on the wall until it
has been included on the network.
Note: Inclusion means add and exclusion means delete.
8
Summary of Contents for SES 302
Page 6: ...a Push spring clips to release b Swing wallplate out and down Wallplate 6...
Page 31: ...NOTES 31...
Page 32: ...32...
Page 33: ...33...
