Nnn-0000nn
© Copyright 2017 SecureALL Corporation
Page
8
of
18
9.
Secure the microswitch with screws and lock washers. The top hole uses a screw, a
lock washer, and a regular washer (Figure 14). The bottom hole uses a clip to capture
the cable with flying leads, which is held in place with another screw and lock washer
(Figure 15).
Figure 14 Figure 15
10.
The cable being held in place by the clip is routed along the side of the pushbar, just
behind the latch assembly (Figure 16), and then fed along the bottom of the pushbar
unit (Figure 17).
Figure 16 Figure 17
11.
The end of the cable is fished under the bottom rail and pulled through until it reaches
the Lockdown Switch (Figures 18 and 19).
Figure 18 Figure 19
Cable clip
Cable routing
along bottom
of pushbar unit
Cable routing
behind latch
assembly
