Mechanical Digital Locks
9 of 11
General Questions for SBL330.SL
How do I change the handing on the SBL330.SL?
Unsecure the grub screw in the handle and rotate the handle 180⁰ past the face of the digital
unit to the opposite side until it then clicks. Then secure the grub screw in the handle. Repeat
for the lever handle of the internal turn.
The lever of my SBL330.SL always operates, how do I lock it
The lever will always be operable as there is a clutch within the handle that allows this to take
place to try and prevent the unit from sustaining damage if forced or vandalised without
inputting of the programmed code.
Does the SBL330.SL have a hold back facility?
No this facility is only available on Knob variations in the Digital Lock range. The SBL365 is the
only lever handle digital lock with some variation of this facility. The SBL365 has a passage
function that allows unlimited access through basic operation of the lever handle, without the
need to input the programmed code, until the feature is disengaged.
The lever handle of my SBL330SL will only withdraw the latch when lifted upwards.
Check the spindle is in the correct position. When
located in the cam of the digital lock the top edge
of the spindle should be leaning towards the
locking edge of the door.
General Questions for SBL365 with latch or lockcase
Can I use my key to gain entry on the SBL365 with Mortice Lock Cases?
Yes, the key can withdraw the latch without the use of the digital lock. The key will execute this
function when it reaches the extent in its range of motion when rotated fully anti clockwise for a
left handed door and fully clockwise for a right handed door.
How do I change the handing on the SBL365?
Unsecure the grub screw in the handle and rotate the handle 180⁰ past the face of the digital
unit to the opposite side until it then clicks. Then secure the grub screw in the handle. Repeat
for the lever handle of the internal turn.
How do I assemble my spindle on the SBL365?
Feed the radius end of the spindle through the collar and secure by
putting the supplied pin through the hole in the spindle. Remove the 3
screws, securing the plate that covers the cam, on the reverse of the
outside unit where the spindle locates and place spindle assembly in and
then re-secure the fixing plate.
