8
INSTALLATION GUIDE
CONCRETE INSTALL
YOU’LL NEED:
•
8mm Drill Bit
•
8mm Dynabolts x 3 (supplied)
•
Washers x 2 (supplied)
STEP BY STEP GUIDE:
1.
Carefully remove bollard from box and
2.
place bollard in car space. The bollard should
be central to the car space and the front of it
should be 1-1.2m in.
3.
Remove the bollard cover.
4.
Using the holes on the base plate as a guide,
drill 3 holes into the ground. If you hit any
underground cabling, simply reposition bollard
slightly.
5.
Put 1 washer under each side of the silver base
plate, at the front.
6.
Put dynabolts in all 3 holes and slowly tighten
with drill.
7.
Connect battery and replace bollard cover,
ensuring it’s locked properly.
8.
Test
–
ensure bollard goes up and down
properly.
9.
P
ack up tools ensuring you haven’t left anything
behind and clean area.
