4
500-33705, Rev A
Ensuring Correct Voltage Setting
NOTE:
Factory default setting is 24 VDC.
1. ENSURE the onboard PCB is set for the correct and desired
operating voltage.
2.
IF
a change is required,
THEN
ACCESS the wiring compartment by removing the wiring
compartment Phillips head screw and cover (see
Figure 1, “Wiring Compartment”),
AND
TOGGLE the 12V/24V slide switch to the desired position.
Figure 1. Wiring Compartment
3. REPLACE the cover and Phillips head screw.
Installing V2M1200/1290 on Out-Swinging Door
Determining the Door Frame Header
1. DETERMINE the type of door frame header and whether a filler
plate, header bracket, or angle bracket is required for installation
(see Figure 2, “Door Frame Installation Options”).
Figure 2. Door Frame Installation Options
