6
To avoid SERIOUS damage to opener, ONLY use
bolts/fasteners mounted in top of motor unit.
WARNING
CAUTION
WARNING
WARNING
ASSEMBLY STEP 2
Set the Belt Tension
• By hand, thread the spring trolley nut on the
threaded shaft until it is finger tight against the
trolley (Figure 1). Do not use any tools.
• Insert a screwdriver tip into one of the nut ring
slots and brace it firmly against the trolley
(Figure 2).
• Place a 7/16" open end wrench on the square
end. Rotate about 1/4 turn until the spring releases
and snaps the nut ring against the trolley
(Figure 3).
This extends the spring for optimum belt tension.
Trolley
Threaded
Shaft
Spring/Trolley
Nu
t
The Cham
b
erlain Gro
u
p, Inc.
Liftmaster Synchro Dri
v
e
Spring Trolley
Nu
t Assem
b
ly
3/5/92 - 5/16 /92 - 5/21/92 - 6/2/92
6/11/92
Nu
t
Ring
Trolley
Threaded
Shaft
Nu
t Ring
Slots
S
qu
are
End
Nu
t Ring
Trolley
Nu
t Ring
Trolley
1" (2.5 cm)
1-1/4" (3.1
8
cm)
BEFORE
AFTER RELEASE
Figure 1
Figure 2
Figure 3
ASSEMBLY STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the
garage door opener until instructed to do so.
• Remove the bolt and lock nut from the top of the
motor unit.
• Place rail onto the bolt mounted on the motor unit
and align the back hole with the hole in the top of
the unit.
• Fasten rail with the washered bolt and lock nut
previously removed. Tighten securely.
Remember
to use only these bolts/fasteners! Any other
bolts/fasteners will cause serious damage to
the opener.
• Cut tape from rail, belt and styrofoam.
• REMOVE STYROFOAM.
• Position belt over the motor unit sprocket.
Motor unit
Sprocket
Washered Bolt
5/16"-18x1/2"
Styrofoam
Rail
Hole
Lock Nut
USE ONLY THIS
TYPE AND SIZE
BOLT
Summary of Contents for Elite 3885C
