140
z
Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
z
Tour: Here you can enable tour function when alarm occurs. System one-window tour.
Please go to chapter 5.3.9 Display for tour interval setup.
z
Snapshot: You can enable this function to snapshoot image when an motion detect alarm
occurs.
z
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
z
Test: Click it to test current motion detect setup (do not need to save). Click Select button
after Region, you can set motion detect area. The default setup is whole region. The blue
zones are the selected area. Please set sensitivity and click Test button, you can see system
only display motion detect status of the blue area. The red flashing area is current motion
detect. See Figure 4-31.
Please highlight icon
to select the corresponding function. After all the setups please click
Save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in
each channel may not be the same.
In Figure 4-26, you can left click mouse and then drag it to set a region for motion detection.
Click Fn to switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure 4-25
Figure 4-26
Summary of Contents for DVR-HD016240M
