188
Figure 5-51
5.5.2 Abnormality
Abnormality interface is shown as in Figure 5-52.
z
Event type: There are several options for you such as disk error, no disk, disconnection,
IP conflict, MAC conflict and etc.
z
Alarm output: Please select alarm activation output port (multiple choices).
z
Latch: Here you can set corresponding delaying time. The value ranges from 10s-300s.
System automatically delays specified seconds in turning off alarm and activated output after
external alarm cancelled.
z
Show message: system can pop up the message in the local screen to alert you when
alarm occurs.
z
Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.
z
Send email: System can send out email to alert you when alarm occurs.
z
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Figure 5-52
5.5.3 Alarm Output
Summary of Contents for DVR-HD016240M
