-
50
SPECIFICATION
REC/PLAY CHECK
At the PASSWORD menu,
Move the cursor to the REC/PLAY CHECK using the , buttons.
Select “ON” or “OFF” to set up the REC/PLAY CHECK using the (-), (+) buttons or jog dial.
VIDEO STANDARD
At the SYSTEM menu,
Move the cursor to the VIDEO STANDARD using the , buttons.
Select the desired value using the (-), (+) buttons or jog dial.
LANGUAGE
At the SYSTEM menu,
Move the cursor to the LANGUAGE using the , buttons.
Select the desired language using the (-), (+) buttons or jog dial.
REMOTE CONTROL ID
At the SYSTEM menu,
Move the cursor to the REMOTE CONTROL ID using the , buttons.
Set the REMOTE CONTROL ID using the (-), (+) buttons or jog dial.
KEY ECHO
At the SYSTEM menu,
Move the cursor to the KEY ECHO using the , buttons.
Set “ON” or “OFF” using the (-), (+) buttons or jog dial.
If you are operating more than one DVR in the same place and wish to use the remote controller, the
remote controller ID setup is required. Otherwise, do not change the default set value and “ON”
should be selected.
Creates the Remote controller ID
Select one of the numbers from 1 to 255, and then press the same number button on the supplied
remote controller before the operation.
If REC/PLAY CHECK is “ON”, the password will be required when you start to record or playback.
The default is “OFF”.
ON : The beep sounds when you press any buttons on the front panel.
OFF : The beep does not sound.
If you select “AUTO”, this DVR can detect NTSC/PAL automatically.
The default is “AUTO”.
