Seebacher GmbH
www.seebacher.de
Phone: +49 (0) 80 41 / 77 77 6
Marktstrasse 57, 83646 Bad Tölz
info@seebacher.de
Fax: +49 (0) 80 41 / 77 77 2
8
Settings
Function
Mode
U-input 1-10V
Control via digital potentiometer from switch manufacturer, or 1-10V dimmer coupler. (It behaves as an ECG
of fluorescent light bulb - the 10V for the 1-10V dimming provides the dimmer.)
U-input 0-10V
Control via external control e. g. PLC with 0-10V
(0-10V voltage comes from the PLC)
A/B/C/D
See table below
Reserve
Not used in this operating mode
Channel 1+2 coupled
The dimmer operates 1-channel, power 1x 1400W
Jumper between outputs LD1 and LD2 is required
Channel 1+2 separately
The dimmer operates 2-channel, power 2x 700W
The outputs LD1 and LD2 must not be jumpered
1-button-dimmer
Control by means of standard buttons on the terminals UE1 and UE2 against GND
Short press = On/Off, long press = dimming
Analog 0(1)-10V
Control analog
In this position the DIP switches 3 are enabled for selection 0-10V or 1-10V
Operation mode setting when using DALI and stand-alone mode with DIP switches „A“ to „D“
DIP A
DIP B
Operation mode
OFF
OFF
Automatic change of operation mode, the start value can be defined in the PC software on the „General“ tab
ON
OFF
Trailing edge
OFF
ON
Leading edge
ON
ON
NonDim
DIP C
DIP D
Setting dimming characteristics such as minimum and maximum values, curves etc.
(see PC software for UD-700-X2)
OFF
OFF
Parameter of 1st column, curve P-linear („General“ in PC software)
ON
OFF
Parameter of 2nd column, curve DALI („General“ in PC software)
OFF
ON
Parameter of 3rd column, curve t-linear („General“ in PC software)
ON
ON
Parameter of 4th column, curve Ueff-linear (with setting for preheating for ESL; „General“ in PC software)
