TriSonus10 dp
5 Operation
11
The following representations show examples of settings:
The preset “Flat” is active.
The
preset “Low-Boost” is active.
The Soft Mode is switched on.
5.4.1
Preset Bank 1 – Free-Standing (Default Settings)
This Preset Bank is to be selected when the TriSonus 10 dp is located free-standing in the room or
is mounted directly next to a video display and there are no adjacent, acoustically hard reflection
surfaces.
Flat:
Preset for single application without any additional subwoofer.
HP:
Flat preset with a higher cut-off frequency for the high-pass filter for
combination with a subwoofer. The higher cut-off frequency allows a
higher maximum sound pressure level to be achieved.
Low-Boost:
Based on the preset Flat with a low-frequency boost. This setting is
useful in full-range applications in which strong bass reproduction is
required, but a subwoofer cannot be used. The achievable low-
frequency level is, however, limited.
Soft Mode:
Additional reduction at the presence frequency range. The Soft Mode
operates independently of which of the three presets is selected and
is recommended for higher listening volumes.
