K24 dp
5 Operation
10
5.3
Setting level
Pressing the Mode button once selects the Level Mode, in which you
can adjust the output volume in 3 dB steps. There are four settings
available: +3 dB, 0 dB (standard), -3 dB and -6 dB. The setting is
done by pressing the Set button. The Level LED lights to indicate
which mode is activated. The four vertically aligned LEDs (lit green in
this mode) indicate which setting is selected.
5.4
Recalling presets
Pressing the Mode button twice selects the Preset Mode. Three different presets with an each
switchable Safe Limit mode are available in each bank for selection via the Set button. The four
vertically aligned LEDs indicate the current selection. The Safe Limit mode is activated in the pre-
set when the bottom of the four vertical LEDs lights up.
5.4.1
Preset Bank 1 – Default Settings
Flat:
Preset for single application or in combination with a subwoofer (e. g.
K Sub 1801 dp and K Sub 1801).
High Boost:
Based on the preset Flat with a high-frequency boost to improve
transparency in a long throw application. The preset is also recom-
mended when using two K24 dp arranged vertically / horizontally next
to each other as a single source..
Soft:
Flat Preset with additional reduction at around 2,5 kHz.
Safe Limit:
Selects more conservative settings for the loudspeaker protection
limiter (e.g. for applications without a supervising technician). The
Safe Limit function is independent of the selected preset. If the Safe
limit function is switched on, the K24 dp is operating in Safe Limit
mode, regardless of which preset is selected.
