X2 dp
5 Operation
11
5.4
Recalling presets
After switching on and starting up, the X2 dp is in Status Mode. Pressing the Mode button twice to
selects the Preset Mode. Three different presets can be called up using the set button. The green
LED above on the right indicates that you are in Preset Mode. The four vertical LEDs show the
selected preset during the selection. If the lower LED lights up in addition to one of the three LEDs
above, the Soft Mode is activated. The following representations show examples of settings:
The following representations show examples of settings:
The preset “Flat” is active.
The
preset “Low-Boost” is active.
The Soft Mode is switched on.
5.4.1
Preset Bank 1 – Default settings
Flat:
Preset for single application without any additional subwoofer.
HP:
Flat preset with a higher cut-off frequency for the high-pass filter for
combination with a subwoofer. The higher cut-off frequency allows a
higher maximum sound pressure level to be achieved.
Low-Boost:
Based on the preset Flat with a low-frequency boost. This setting is
useful in full-range applications in which strong bass reproduction is
required, but a subwoofer cannot be used. The achievable low-
frequency level is, however, limited.
Soft Mode:
Additional reduction at the presence frequency range. The Soft Mode
operates independently of which of the three presets is selected and
is recommended for higher listening volumes.
