G3 dp
SEEBURG acoustic line
6
Part 1 – Connections and indicator functions
Connectors
•
XLR In:
The G3 dp is controlled via a conventional symmetrical NF
cable. For signal loop-through use the male Loop Thru XLR In. For full
conduction the connected signal source should deliver at least 6 dBU
undistorted.
•
PowerCon (grey)
115-230 VAC Loop Thru input. This is required if
power is to be supplied to several active speaker boxes and only a
115-230 Volt AC lead is being used. Please observe the maximum
permitted connected load. In practice, power can be supplied to up to
two additional systems.
•
PowerCon (blue):
Power supply 115-250 VAC. This plug has the
same function as an on-off switch. Ensure that a 115-230 VAC mains
voltage is available. After switching on (clockwise rotation until it snaps
into place), the system starts up and is ready for use within 3 seconds.
Avoid continuous switching on and off, particularly when the system is
under sustained load.
