SEEBURG acoustic line
15
Assembly and disassembly – groundstack operation
Using the stacking frame (reversed flying frame with extenders), a stacked
Galeo array of up to 6 elements is possible without further ballasting. Insert the
extenders into the holes in the flying frame and secure these using ball lock
pins according to the assembly instructions.
The floor space must be skid-proof, clean, even and sufficiently sustainable.
Due to possible wind force, the top edge of the array must not be higher than
5m above ground level. Observe the structural analysis certificate.
Larger arrays are possible of course, but these must then be braced and
secured accordingly in order to prevent toppling in windy conditions (separate
certificate is required!).
Do not assemble groundstacks in areas that are accessible to the public or
where they can possibly even be knocked over in a panic situation.
Using the stacking device on the top of the Galeo Sub, the Galeo can be
mounted directly onto the Galeo Sub without the need for further stacking
frames or similar devices. Stack the woofers first and connect them via the
fittings. Then stack the Galeo units on top of the woofers.
The structural analysis certificate contains the following cases for
stacked
operation at open-air events and up to wind force 8:
•
up to 6 Galeo on 1 Galeo Sub
•
up to 6 Galeo on the groundstack frame with extenders
Galeo groundstack, short extenders at front,
long extenders at rear
