Seeley MobileMAX Series, Conversion Manual

   MOBILEMAX ASSEMBLY MANUAL  

|  

5

CONVERSION INSTRUCTIONS

REMOVAL INSTRUCTIONS

WARNING: ELECTRICAL WORK MUST ALWAYS BE 

CARRIED OUT BY A QUALIFIED ELECTRICAL WORKER

Ensure that the cooler cannot be turned on

 whilst 

work is being carried out.

Remove all pads

 (side panels) from cooler and put them 

safely aside allowing access to the inside of the cooler. 

ILL725-A

PACKING LIST

This kit contains the following components:
• 

a 100 litre tank with wheels fitted,

• 

a floating platform for the pump, with pump bracket 

fitted.

•  a replacement hose assembly
•  cord storage hooks, cord restraint glands and 

fasteners,

•  a grille outlet and a grille frame and fasteners
•  pop rivets and fasteners.
•  cable ties.
•  1/2” brass nipple and lock nut.
• 

Mains lead 3 pin 13 amp x 6m (fit plug to suit 

location)

• 

Communications Lead 6 Pin 1.5m CPMD to Switch 

Plate Control

•  Cable Gland 20mm to seal the 1.5m communications 

lead hole drilled in the cooler

• 

Enclosure, Cable Glands 16mm, Terminal Strip and 

mounting screws for connection of field wiring mains 

power to an IEC plugged cable to fit into the CPMD.

•  Drilling and cutout Template
Unpack the kit to ensure it contains the above 

components.

Additional items required to assemble the kit include;

•  an electric drill,
•  an electric jig saw or alternatively a narrow bladed 

hand saw,

•  a sharp knife,
•  a philips head screwdriver,
•  a pop-rivet gun,
•  sandpaper,
•  a tape measure, ruler and marker pen.
•  a vacuum cleaner,
•  a bucket of soapy water and clean loth,
•  masking or packing tape,
• 

20mm (3/4”) spade drill bit

• 

25mm (1”) spade drill bit

• 

16mm (5/8”) spade drill bit (Australia, South Africa 

and Europe)

• 

3mm (1/8”) drill bit

• 

5mm (3/16”) drill bit

• 

Teflon tape or approved sealing compound.

•  scissors or a sharp blade knife,

MODIFYING THE COOLER

The cooler requires some modification prior to fitting to 

the MobileMAX Tank.
Some components will be removed and set aside for 

later fitment to the MobileMAX Tank while others will be 

discarded.

Remove packaged components located in the fan area 

and set aside for later use.

Remove the float valve

 by undoing the threaded in-line 

connector. 

Set the float assembly aside for later use. 

Remove the plastic washer and “O”ring from inline 

connector.
Discard the plastic inline connector only.