MOBILEMAX ASSEMBLY MANUAL
|
7
CONVERSION INSTRUCTIONS
For Australian, European or South African coolers use a
16mm drill bit to drill through the side of the rear left hand
recess.
For American coolers use a 20mm (3/4”) drill bit to drill
through the side of the rear left hand recess.
SERVICE CORD FITMENT
The service cord requires a hole for entry into the cooler.
ILL2750-A
ILL2751-A
Fit the appropriate cord restraint gland
supplied in the
kit.
Pass the service cord through the holes in the tank and
through cord restraint gland allowing enough cord to
reach the CPMD control box.
Tighten the cord restraint gland, locking the cord.
ILL2752-A
ASSEMBLY OF TANK KIT COMPONENTS
The float valve, removed earlier, is to be refitted to the
MobileMAX tank.
ILL2753-A
Using approved tape/sealing compound on thread of
brass nipple supplied in the MobileMAX Tank kit,
fit the
float valve
, ensuring correct orientation of “O”rings and
washer.
BE SURE THE FLOAT REMAINS HORIZONTAL
.
ILL2755-A
ILL2754-A
Summary of Contents for MobileMAX Series
Page 15: ...DRILLING TEMPLATE INFORMATION ...