MOBILEMAX ASSEMBLY MANUAL
|
9
CONVERSION INSTRUCTIONS
ILL2757-A
FRONT GRILLE ASSEMBLY
The front grille assembly is made up of a grille and a
grille frame. The grille frame is designed to be used in
one orientation in lower model coolers and inverted for
fitment to taller model coolers.
Position the grille frame to suit your model of cooler.
ILL2764-A
All coolers will require the removal of the screws from
around the opening of the panel outlet as they will get in
the way of the frame.
ILL2765-A
Remove the grille from the grille frame assembly and set
aside. Position grille frame over the air outlet, using grille
frame as guide, drill 3mm (1/8”) holes through cooler
side.
Note the orientation of the notch in the frame of the grille.
For small cabinet coolers (EA90) the notch locates under
the edge of the lid (Fig. 14 LHS) and for a large cabinet
cooler (EA120) the notch is located at the bottom of the
frame. (Fig. 14 RHS)
Remove these fasteners and put aside. For those coolers
that had previously been used with an integral flexible
duct, trim the flexible duct right back as far as it can be
trimmed with the sharp knife.
Conduct a test fitment of the grille to the grille frame to
check alignment and squareness.
Secure the grille frame to the cooler with the screws
supplied with the grille frame assembly.
Attach grille to grille frame using screws supplied.
14
Summary of Contents for MobileMAX Series
Page 15: ...DRILLING TEMPLATE INFORMATION ...