INTRODUCTION
Congratulations on choosing Breezair air
cooling.
Your air cooler is built from the highest quality
materials and engineered to provide many
years of economical, trouble free cooling.
Please take a few minutes to read these
instructions so you have a full understanding
of how to operate your air cooler. Your
installer should demonstrate the features and
procedures set out in these instructions. The
installer should also provide you with a Model
and Serial number, which can be filled out on
the last page.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
EFFECTIVE COOLING
To provide efficient cooling or ventilation the
building must have sufficient exhaust openings
to outdoors in the form of doors, windows or
other vents. To assist air circulation, open
windows or doors that are furthest from the
outlet vent in each room. In every room that has
an outlet vent, provide an exhaust opening
about 2 or 2.5 times the size of the outlet vent
in the room. Where the design of the building
prevents adequate exhaust, consideration
should be given to the provision of mechanical
extraction such as an exhaust fan.
Total minimum openings for the whole building
are demonstrated by the following table:
Please note that an average size door is 1.5m.
2
SEELEY INTERNATIONAL –
OWNER’S MANUAL
3
TBA250
2.0m
TBA350
2.5m
TBA450
3.0m
TBA550
4.0m
2
2
2
2
COOLER MODEL EXHAUST OPENING
WALL CONTROL FUNCTIONS
STARTING YOUR COOLER
POWER
The
button turns the air cooler on
and off.
There are two modes of operation to
choose from, Automatic mode or Manual
mode. When the air cooler is turned on, it
will start in the mode of operation it was in
when last turned off.
If your air cooler has not been operated for
a while, then when you start it, “Pre Cool
Cycle” may sometimes flash on the display
as shown.
This indicates that the water pump will
operate to saturate the cooling pads for a
few minutes before the fan is turned on.
This is to ensure that when the fan starts,
only cool air enters the building.
®
TBA Evaporative Cooler
Summary of Contents for TBA250
Page 2: ......
Page 74: ...16 ILL1135 B 2 x 5 0mm Plasterboard or 2 x 6 0mm Brick 72 TBA Evaporative Cooler ...
Page 75: ......
