USING THE COOLER
POWER
Now that you have read these instructions,
press the
button to turn your air
cooler on. If the air cooler has not operated
for a while , “Pre Cool Cycle” will flash on the
display. The “Pre Cool Cycle will begin and
will take only a few minutes to complete. After
this time, the fan will come on automatically,
and you can enjoy the comfort of cool fresh
air!
AIR TOO COLD
COOL
AIR NOT COLD ENOUGH
COOL
You can experiment with the settings on
your wall control. This is the best way to get
the most from your air cooler.
With the cooler running in Automatic mode, you
may find that you are too cold or that the air
cooler is blowing too much air. Press
to
lower the automatic temperature setting and
reduce the amount of cooling.
If you are too cold with the cooler running in
Manual mode, then press
to reduce the fan
speed. You can also circulate fresh uncooled air
by pressing
until “Vent” displays.
You may find that with the air cooler running in
Automatic mode, you are not cool enough.
Simply press
to increase the cooling rate.
If you are not cool enough with the air cooler
running in Manual mode, then press
to
increase the fan speed. Ensure that cooled air
is circulating by pressing
until “Cool”
displays.
t
t
s
s
This air cooler comes with an automatic
drain valve or an alternative simplified bleed
system.
If the drain valve was installed instead of
the alternative bleed system then your
cooler will automatically replace the water
during operation when the water salinity
becomes too high. This ensures the water
is always fresh and helps maintain your
cooler in good condition to ensure optimum
cooling performance. Alternatively and if
necessary, the air cooler can be set to
replace some water after a set time of
cooling operation. The frequency of the
automatic drain may have been adjusted by
your installer.
You can adjust the method of water
replacement with the following steps.
1.When the cooler is off, press and hold
.
2.While still pressing
, press
.
3.A number will display which corresponds to
the selected salinity control method as shown
in the table below.
Press
or
to change the displayed
number to the desired salinity control
method.
4.Press
to set your selection.
AUTOMATIC DRAIN VALVE
COOL
POWER
s
s
s
t
Display Number
Salinity Control Method
00
01
Salinity Sensor
Timed Drain
STANDARD
6
SEELEY INTERNATIONAL –
OWNER’S MANUAL
7
WALL CONTROL FUNCTIONS
DRAIN VALVE AND BLEED SYSTEM
®
TBA Evaporative Cooler
Summary of Contents for TBA250
Page 2: ......
Page 74: ...16 ILL1135 B 2 x 5 0mm Plasterboard or 2 x 6 0mm Brick 72 TBA Evaporative Cooler ...
Page 75: ......
