Rostock MAX v2 Assembly Guide – 4thEd.
Repeat this task for the other two Ball Joint Arms.
12.2 – Installing the Ball-Cup Delta Arms & Effector Platform
For this task, you'll need the following components:
Before you begin this task I recommend
that you move the hot end out of your way by
looping it over the Y tower.
Make sure you've got each carriage moved
to the bottom of the machine. It'll be easier to get
the arms installed with them in that location.
Take two Ball-Cup Delta Arms and press
them on to the Ball Joint Arms as shown.
The cup on the arm will make a soft click
sound as it seats fully on the ball arm.
12 – Installing the Effector Platform and Delta Arms – 106
Fig. 12.1-3: Completed platform.
Fig. 12.2-1: Out of the way...
Fig. 12.2-2: Fitting the arms.