Rostock MAX v2 Assembly Guide – 4thEd.
Rostock MAX v2 Electronics and Hardware Pack #3, Rev 3 [84376]
[___] (1) RAMBo Electronic Control Board with screw terminals and
end stop wires. [26710]
[___] (1) USB Cable. [26708]
[___] (1) Onyx Heated Bed Sub-Assembly Pack [58770]
[___] (1) LCD Smart Controller with SD card, LCD to RAMBo
Adapter Kit and 1 Soft Touch 5mm knob. [26720]
[___] (4) NEMA 17 Stepper Motors (4800gcm holding torque). Used for
three motion axes and extruder drive. [26501]
[___] (1) 25x25x10mm 12VDC fan. Used to cool the PEEK section
on the hot end. [26309]
This fan is installed after you print the PEEK fan shroud, as covered in
the User Guide.
[___] (1) 40x40x10mm 12VDC fan. RAMBo cooling fan. [26177]
2 – Visual Bill of Materials – 17