Rostock MAX v2 Assembly Guide
There are two tie down points located in a straight line between the X and Z towers. These two
points are used to retain the end stop wires that go from the X to the Z tower.
Insert a wire tie from below as shown below and pull it tight and clip off the “tail” of the wire
tie.
110
Fig. 7-43: X-Z path tie down points.
Fig. 7-44: Tie ready to fix in place.
Fig. 7-45: Tightened & clipped.
Summary of Contents for Rostock MAX v2
Page 25: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 1 25 ...
Page 26: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 2 Melamine Parts Sheet 3 26 ...
Page 27: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 4 27 ...
Page 171: ...Rostock MAX v2 Assembly Guide 171 Fig 14 8 Spool holder support installed ...