Rostock MAX v2 Assembly Guide
Next, slide the hot end ring spacer over the
hot end.
Now fix the hot end in place by re-installing the
large retaining nut and tightening it.
Now flip the hot end over and press the wiring into the
strain relief notch in the hot end mounting plate as shown.
Bind the hot end wires into place using a
wire tie. Insert the wire tie through the slot
highlighted in green in Fig. 11-25.
155
Fig. 11-22: Hot end mounting plate.
Fig. 11-23: Spacer installed.
Fig. 11-24: Nut attached.
Fig. 11-25: Strain relief notch.
Fig. 11-26: Hot end wires tied into place.
Summary of Contents for Rostock MAX v2
Page 25: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 1 25 ...
Page 26: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 2 Melamine Parts Sheet 3 26 ...
Page 27: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 4 27 ...
Page 171: ...Rostock MAX v2 Assembly Guide 171 Fig 14 8 Spool holder support installed ...