Rostock MAX v2 Assembly Guide
Pull the tube through the loom until you have enough to insert the end into the press fit
connector on the bottom of the EZStruder.
Finish by inserting the tube into the hot
end's press fit connector.
157
Fig. 11-29: Exiting the loom at the top.
Fig. 11-31: Bowden in the hot end.
Fig. 11-30: Bowden inserted into the
EZStruder.
Summary of Contents for Rostock MAX v2
Page 25: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 1 25 ...
Page 26: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 2 Melamine Parts Sheet 3 26 ...
Page 27: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 4 27 ...
Page 171: ...Rostock MAX v2 Assembly Guide 171 Fig 14 8 Spool holder support installed ...