Rostock MAX v2 Assembly Guide
http://reprap.org/wiki/Triffid_Hunter%27s_Calibration_Guide
The other portions of his calibration guide doesn't really apply to the Rostock MAX v2, so it's
not necessary to read unless you're simply curious.
20 – First Print: PEEK Fan Shroud
For your first (and second!) prints, you're going to need to have ABS filament handy. This is
because the PEEK and Layer fan shrouds can be exposed to temperatures that would turn PLA shrouds
into a gooey mess. You're also going to need the 25x25x10mm PEEK fan itself.
Configuring the Slicer
The process of converting a 3D model into something you can print is called “slicing”. The
243
Summary of Contents for Rostock MAX v2
Page 25: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 1 25 ...
Page 26: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 2 Melamine Parts Sheet 3 26 ...
Page 27: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 4 27 ...
Page 171: ...Rostock MAX v2 Assembly Guide 171 Fig 14 8 Spool holder support installed ...