Rostock MAX v2 Assembly Guide
Once the open file dialog opens, navigate to where you unpacked the file. If you downloaded
the MatterControl presets file, the PEEK fan shroud file will be found in the “STLs to include”
directory. It's called “70766 EZFan Shroud r2.stl”
Now that you've got the file loaded, we need to load filament into the printer!
Loading Filament
It's extremely simple to load filament into the EZStruder. Just place your index finger on the
top of the extruder and your thumb on the tension lever (marked by the arrow below). Press the tension
lever down and feed the filament by hand along the path marked by the green arrow. There is a small
opening behind the tension lever that the filament will enter into the extruder through.
248
Fig. 20-13: The PEEK fan file.
Summary of Contents for Rostock MAX v2
Page 25: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 1 25 ...
Page 26: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 2 Melamine Parts Sheet 3 26 ...
Page 27: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 4 27 ...
Page 171: ...Rostock MAX v2 Assembly Guide 171 Fig 14 8 Spool holder support installed ...