Rostock MAX v2 Assembly Guide
Installing the Upper Idler Bearings
For this task, you'll need the following components:
First you'll need to put together two idle bearing spacers with one bearing. This is the same task
you did for the lower idler bearings.
Now install the assembled idler using a 1.75” pan
head screw as shown below.
99
Fig. 7-19: Upper idler bearing.
Fig. 7-20: Screw inserted.
Summary of Contents for Rostock MAX v2
Page 25: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 1 25 ...
Page 26: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 2 Melamine Parts Sheet 3 26 ...
Page 27: ...Rostock MAX v2 Assembly Guide Melamine Parts Sheet 4 27 ...
Page 171: ...Rostock MAX v2 Assembly Guide 171 Fig 14 8 Spool holder support installed ...