7. INSTRUCTIONS FOR USE OF THE COOKER HOOD
7.1 The cooker hood has 3 speeds of ventilation. Depending on the amount of evaporation during
cooking, you can choose a low, medium or high of ventilation level.
7.2
Before cooking, turn on the hood in the required operating mode. It is recommended to
continue work of the cooker hood for 3-5 minutes after cooking
, thus the air in the kitchen will be
cleared from the residue of the vapours.
7.3 On the decorative glass of your cooker hood there is a touch switch for operating modes of the engine
and lighting lamps (
Pic. 6
):
1
– low speed,
2
– average speed,
3
– high speed,
0
– fan is off.
The touch switch with the symbol of the light bulb
, intended to turn on the lamp at insufficient
illumination of the working area of the cooker:
0
– light is off,
I
– light is on.
7.4. Attention!
Before cleaning the extractor hood, disconnect it from the electricity.
7.5.
Use a damp cloth soaked in warm water with a neutral detergent for external cleaning of the painted
extractor hood.
7.6. Never use abrasive detergents, coarse sponges or detergents containing soda, acid, chlorides or
solvents to clean the extractor hood.
7.7.
When cleaning, avoid getting moisture on the current-carrying parts of the extractor hood, and wipe
the surfaces with a soft cloth after washing.
7.8.
The aluminum filter, holding oil and dust from the air, is clogged and should be washed after being
soaked in hot water with an effective detergent once every 1.5 to 2 months.
Changing the color of the filter
after washing does not affect the quality of its work.
7.9.
To remove the aluminum filter, press the spring latch and remove the filter from the panel. Install the
filter in reverse order.
Do not install the filter after washing until it is completely dry.
7.10.
The carbon filters, used during recirculation mode should be changed every 3-6 months depending
on the extractor hood use. Filters are installed on the T-like
stab of the cover of the turbofan by axial
pushing and clockwise rotation.
7.11.
LED lamps
are installed on the extractor hood for lighting the working area of the cooker. Before
starting lighting lamps substitution, disconnect the extractor hood from electricity, and leave the lamps to
cool. To replace the lamp, remove the aluminum filters, push the holder of the cartridge so that the lamp
came out of the body of the extractor hood and remove it by turning it counterclockwise. Replace it with the
new one with the same characteristics and install filters.
Pic. 6
