17
CAUTION
Never switch between ranges while connected to high voltage to avoid personal harm and/or damage to the meter.
6. Disconnect test leads from voltage source then switch meter to
OFF
to conserve power.
3.3 RESISTANCE / CONTINUITY MEASUREMENTS
CAUTION
Remove power from circuit under test before making resistance measurements.
1. Verify that power is off and that any capacitors are discharged in circuit about to be tested.
2. For resistance measurements: In AUTO (default) mode, set function selector to
Range is automatically selected for best
resolution. If the meter is operating in manual ranging mode, select range that closely matches actual resistance expected.
3. For continuity measurements:
Set function selector to
position.
Plug black test lead into COM plug. Plug red test lead into Hz
F plug.
5. Connect test leads across desired measuring points.
Summary of Contents for MW3105
Page 1: ...MW3105 DIGITAL CLAMP MULTIMETER...
Page 2: ...2 M MW3105 A 01...
Page 6: ...6 Figure 1...
Page 27: ...27...
