SEQUENCER
Technical brochure
FI 72.0540.0920E
Page 8 of 12
FRONT FACE :
SETTINGS AND OPERATION:
The various parameters are adjusted as follows:
- Press the "SELECT" key until the yellow "menu" led lights up in front of the parameter to be set and press the "+"
and "-" keys to obtain the desired value.
- Then return to the "CYCLE" position using the "SELECT" key. Each parameter is saved in a memory when going
to the next step or when automatically returning to the "CYCLE" position.
Remarks
:
- The return to the "CYCLE" position is automatic after 60 seconds.
- Each parameter can be viewed at any time during the operation of the device.
See the correspondence with the number below.
Signaling
Yellow led
Parameter setting menu
FIXE (1)
FLASHING (2)
FIXE (3)
FLASHING (4)
FIXE (5)
FLASHING (6)
FIXE (7)
FLASHING (8)
Green Led :
On if input « loop
control » present
(=1)
3 digits display
red led
Red led :
On if
presence of a
fault
