34
• If you decide to change anything else in the timer programme,
please leave this section for now and read ‘Setting the timer’
on page 35.
7 Press the MENU button to finish.
If you have made a mistake, please see ‘How to erase a timer
programme’ on page 36.
8 Press the OK button to confirm the timer programme. The
video timer is now set. The information has been stored in a
timer block.
• If you have set the video to start recording a second
programme, before the first programme has finished, you will
get a warning and the video recorder will go back to step 6.
9 Put a cassette (with a safety tab) into the video recorder.
Switch the video recorder to stand-by with the POWER button
or the
button. ‘TMR’ will light up red in the video
recorder display.
• The video recorder will only make the recording if it is
switched to stand-by with the POWER or
button.
TIMER PROGRAM (ONCE)
PR
03
START TIME
21:20
END TIME
22:20
START DATE
14/10(SAT)
TAPE SPEED
SP
PDC
ON
/
:CORRECT
OK:CONFIRM MENU:END
1. INSERT THE CASSETTE.
2. TURN THE VCR OFF.
TMR
Programmed recording with VI (continued)
6 Press the OK button to confirm your choice in step 5 and
display the timer programme information. If you do not press
another button within one minute, the timer display will go off
and you will have to start from step 2 again.
• When you use VI for the first time for a television
channel, the ‘PR’ line at step 6 will be flashing ‘- -’. Press the
number buttons 0 to 9 for the television channel you want to
record, for example if you have a satellite receiver on video
recorder programme number 6 (PR 06), press 0 and 6. If you
want to record from other equipment that is connected with a
scart cable, press the PR+ button on the remote control to
make ‘AV’ appear on the ‘PR’ line. After you have used
VI for a television channel, the video recorder
remembers the right programme number or the AV channel
(scart cable) when you use a PlusCode number again for that
channel.
• PDC will be on. Please read ‘ Programme delivery control’ on
page 33 if you do not understand PDC.
TIMER PROGRAM (ONCE)
PR
03
START TIME
21:20
END TIME
22:20
START DATE
14/10(SAT)
TAPE SPEED
SP
PDC
ON
PR+/-:SELECT (AV)
0-9 : SETUP (PR)
/
:CORRECT
OK:CONFIRM MENU:END
r e c o r d i n g s
P r o g r a m m e d
